DEQX Products
- PDC-2.6 |
|
 |
Digital Calibration
Processor / Crossover for Loudspeakers & Room Acoustics |
|
The DEQX Calibrated™ PDC-2.6
Processor is a 2-input, 6-output digital processor offering individual
driver correction with extremely high order digital crossovers (typically
100dB/octave, but up to 300dB/octave) in addition to necessary room
correction.
For best results, speakers should be bi-amped (two-way)
or tri-amped (three-way). Speakers with 'bi-wire' or 'tri-wire'
connectors are easily adapted to DEQX correction. Alternately, existing
crossovers can be bypassed. Single connector speakers (with passive
internal crossovers), or active speakers, can also be DEQX Calibrated™.
These
corrections provide an accurate frequency response and a remarkable
improvement in imaging due to high frequency phase coherence between
speakers. Crossovers can also be applied to one or two corrected
sub-woofers.
Once the the loudspeakers are corrected, the PDC-2.6 can
perform a detailed measurement of the speakers in the listening environment
with user-definable digital parametric equalization available to
optimize the room response and speaker setup.
|
PDC-2.6 Rear Panel shown
with optional Balanced Analog Outputs. (Click to enlarge) |
 |
Features
Digital Speaker Correction (stereo, fully anechoic, amplitude and
phase)
Realtime Digital Parametric Equalization
Detailed room measurement capability for optimum room/speaker
setup
Room Correction (Automatically calculated based on detailed room
measurements)
Custom correction of each playback environment
Stereo digital crossovers (6dB/octave steps to 300dB/octave)
32-bit, floating-point, 240-MFLOPS sustained processing with dual
SHARC DSPs
Extremely low latency processing (from 1.9 msec)
Audiophile grade Op-Amps (Burr Brown)
Six 192KHz 24-bit ulta low jitter D/A converters
Stereo analog inputs, balanced (XLR) and unbalanced (RCA)
Stereo digital inputs, S/PDIF and AES/EBU
Six analog outputs, unbalanced RCA
Digital volume control allows digital sources to be input directly
Mic input for optional DEQX Calibrated™ measurement microphone
Compact 1U design (1 3/4" H x 17" W x 11.5" D)
19-inch rack mount hardware included
100-240VAC auto sensing operation, 30VA
PC-based set up via USB or RS-232 for initial measurement, correction
and user-defined options
Instant selection of 4 user defined target room/speaker curves
DEQX Basic Calibration Kit comprising DEQX Calibration Software
and calibrated measurement microphone
Free downloadable software and firmware updates
Online and telephone support
Membership of DEQX Users Group (online)
|
Options
Upgrade to DEQX Reference Calibration Kit (includes reference grade
30kHz measurement microphone)
Choice of black or silver front panel
Either
Six balanced analog outputs (XLR)
-or-
Six digital outputs - AES/EBU (XLR), S/PDIF (RCA phono)
|
Find out more about
owning the DEQX Calibrated™ PDC-2.6P
(Preamp Model) |
